The Seakeeper 3DC is designed to achieve 70 to 90% roll reduction on boats up to 10 tons, vessels ~30-40′. The Seakeeper 3DC requires only modest electrical power, has no outside appendages, and can be installed off centerline, if necessary. Its computerized control and vacuum technology make it the first truly practical, and only modern, anti-roll gyro.
|Rated Speed||6,400 RPM|
|Angular Momentum at Rated RPM||3,000 N-M-S|
|Anti-Rolling Torque at Rated RPM||6,509 N-M|
|Spool-up Time to Rated RPM||38 minutes (6,400 RPM)|
|Spool-up Time to Stabilization||27 minutes (5,440 RPM)|
|AC Motor||900 Watts Max (from True Sine Inverter)|
|DC Control||70 Watts|
|AC Motor (sea state dependent):||450 – 900 Watts (from True Sine Inverter)|
|DC Control:||100 Watts|
|AC Input Voltage:||110-230 VAC (+/- 10%), 50/60 Hz, Single Phase (from True Sine Inverter)|
|DC Input Voltage:||12 VDC @ 15 Amps|
|Sea Water Supply to Heat Exchanger||22 LPM (6 GPM) maximum|
|7.6 LPM (2 GPM) minimum|
|Ambient Air Temperature||0° – 60° C (32° – 140° F)|
|Weight||358 kg (790 lbs) bolt-in installation|
|Envelope Dimensions||Length x Width x Height|
|0.765 L x 0.757 W x 0.628 H (meters)|
|30.1 L x 29.8 W x 24.7 H (inches)|
|Noise Output||At full operating RPM, steady state noise measured in the factory at a 1 meter distance measures 62-64 dBC. (Sound levels may be higher during spool-up)|
What Seakeeper is right for me?
Frequently Asked Questions
It is a computer controlled gyroscope that eliminates most boat roll, including the fatigue, anxiety and seasickness that goes with it. Because of this game changing effect, PR Nautica have successfuly installed over 30 Seakeeper units worldwide.
Typically, the Seakeeper weighs between 2 and 4% of boat weight, requires half or less the power of air conditioning, and fits in available space down in the after part of the hull. Nothing extends outside the hull and the Seakeeper is a small percentage of the overall volume of the boat.
Seakeepers are sutiable for most boats 30 feet and above. PR Nautica can install the best option on new vessels and as a retro project.
Up to 20 tons, vessels 30-50′: Seakeeper 5
Up to 35 tons, vessels 50-65′: Seakeeper 9
Up to 70 tons, vessels 65-80′ : Seakeeper 16
Up to 100 tons, vessels 80-100′: Seakeeper 26
Greater than 100 tons, vessels >100′: Seakeeper 35
Yes, we can fit Seakeepers to both new vessels and aftermarket. The time of a retrofit installtion will vary depending on the Seakeeper and the model of the vessel. Typical installation time is 1-3 weeks. Get in touch for a custom quotation.