Pre-Delivery Inspection

Complete a full Pre-Delivery Inspection with multiple visits to the factory and audit list raised and issued to all parties clearly listing current defects. Includes a Sea Trial, full systems check and commissioning of systems

Back-up Windlass

To supply and fit a lewmar V6 electric windlass to be used as a back-up windlass to the main factory fitted windlass, to include the re-positioning of the main windlass, the supply and fit of the back-up windlass, the supply and fit of a custom made chain roller and the supply and fit of a nylon deflector to prevent the chain from scratching the stem head stainless steel

Fore deck Awning

To supply and fit a fore deck 4 post awning, awning post will be fitted further outboard and further forward than standard

to include manufacture and fit of GRP pods to level surfaces for socket installation

Cameras

To supply and fit CCTV with one camera fitted under aft steaming light viewing bathing platform and one in engine room, cameras will be connected to upper and lower helm plotters with selection switch at upper and lower helm (cameras used will be Raymarine CAM200IP)

Platform Remotes

To supply and fit a bathing platform remote control sensor c/w 2 x remote controls

Deck Wash

To supply and fit a freshwater deck wash outlet in the transom

Cockpit Servery Sink

To supply and fit a stainless steel square sink in the cockpit servery, the sink will be recessed into the servery with a fold down tap,

the top infill panel will be hinged and made from the same Avonite as the worktop so this will blend in when not in use,

Protective Covers

To supply a weatherproof protective cover for the Fore deck seating

To supply a weatherproof protective cover for the Cockpit seating

To supply a weatherproof protective cover for the Foredeck Sunbed

Anchor Swivel

To supply and fit an Ultra marine 12mm stainless steel anchor swivel

Vinyl Wrap to Hardtop

To supply and fit vinyl wrapping to the hardtop support legs in the colour of choice

Port Side Helm Seating

To supply and fit a circular table and sliding stainless leg to the Port side of helm seating area,

table will be locked in position but will slide on seat face to position where required

Switch Plates

To remove all the socket and switch cover plates throughout the boat and replace with the plates of the selected colour

Watermakers

To supply and fit a Idromar MC2J water maker into the engine room, water maker will be mounted over the aft end of the engine and and will be mounted as high as possible, Priced as each

Cost assuming that the factory supply and fit x 2 water maker inlet skin fittings

Navigation Upgrade

To supply and fit 4 x Raymarine Axiom 12 Pro RVX Hybrid touch 12″ MFD`s with built in RVD Sonar,

Raymarine RS-150 GPS, Raymarine cup & pointed ultra sonic wind/weather station.

To include the replacement of the upper and lower helm panels to accommodate the displays.

Dining Area Blinds

To supply and fit 2 x Walnut Venetian blinds to the dining area panoramic window

100amp Shoreline

To supply and fit a 100amp Glendenning shore support system, to include the manufacture and fit of a shore support locker into the face of the transom step, the reworking of the AC contactor box and the supply and fit of a manual change over switch

The Functionality then becomes:

Original Shorelines powered:

Shoreline 1 only Leg A & B powered

Shoreline 2 only Leg B only powered

Shoreline 1 & 2 Shoreline 1 Leg A, Shoreline 2 Leg B

(Above as standard)

New Shoreline Powered.

Shoreline 1 & 2 won’t select.

New Shoreline: Shoreline 1 Polarity lights display new Shoreline and Both Leg A and B powered when Rotary switch is in the Shoreline position.

Additional lights

To supply and fit 6 x additional courtesy lights above the dining table